mjs2011
Full Access Member
Today was the warmest day on forecast until March, It hit 32 degrees!!! So I went out and got my IP and injectors pulled to prepare for a full refresh.
Everything went smoothly. However, I do have a few questions. Firstly, what should I be using to plug the holes where the injectors were. At this point, there is nothing covering them. Secondly, some of the injectors looked pretty rough, and some had some buildup below the copper washer. Is it necessary to clean out the bore before the new injectors are installed?
The injectors are marked 7/90 (The manufacture date?) and have a D stamped on the side of the hex. BB are the recommended type of injectors to reinstall, correct?
Attached is a picture of the worst injector. It had some goo and rust all along the body, as well as some carbon on the tip.
Lastly, what preparations should I make to my IP before I send it to be rebuilt? Right now it is super dirty.
Everything went smoothly. However, I do have a few questions. Firstly, what should I be using to plug the holes where the injectors were. At this point, there is nothing covering them. Secondly, some of the injectors looked pretty rough, and some had some buildup below the copper washer. Is it necessary to clean out the bore before the new injectors are installed?
The injectors are marked 7/90 (The manufacture date?) and have a D stamped on the side of the hex. BB are the recommended type of injectors to reinstall, correct?
Attached is a picture of the worst injector. It had some goo and rust all along the body, as well as some carbon on the tip.
Lastly, what preparations should I make to my IP before I send it to be rebuilt? Right now it is super dirty.