IDI Bronco in utah

[Brimmstone]

The 44hd knuckles are a direct swap onto a regular 44ttb in a bronco. I couldn't remember what it was called. The 50ttb knuckle will mount after reaming the tapers so the ball-joints will fit.

 

[BlueOvalBud]

Thanks for the info!!

 

[Brimmstone]

You'll also need the 50 stubs to mount onto your old inners. Also while yes I did do it and it worked for me if I did another one I would still mock everything up first before I started modifying the beams to make sure.

 

[Brimmstone]

Just went and checked some of my notes. The 3850 lb axle was a direct swap to a bronco 44ttb. The 4600 knuckle needed the machining.

 

[BlueOvalBud]

Just went and checked some of my notes. The 3850 lb axle was a direct swap to a bronco 44ttb. The 4600 knuckle needed the machining.

Assuming the 3,850 is the 44HD and the 4,600 is the 50?
I think my buddy's truck with the Dana 50 front says 4,600 on the door jamb sticker.

 

[Brimmstone]

I'll look at the wrecked truck down at my old job in the morning when I finish the headgaskets job I'm doing down there. The 50ttb is the one with the dana 60 hubs on it. I personally haven't done more than ball-joints to a ttb in a few years all my trucks but the Bronco and the Flatbed have 60s in them. I did this going on about 10 years ago.