stuborn nut
Registered User
So this is the start if a rebuilt engine for my rig. I have been collecting parts and trying to decide what I was going to do for about 3 years now. So what I decided was 6.9 is the least expensive base engine for me to put together so I had a little left over for some of the extras I wanted. This is what I got so far IH std 6.9l inframe set, heads got a handful of new valves and all new guides surfaced and comp springs. Block was honed decked and cleaned. I am working on tapping the soft plugs to 1 1/4" pipe for plugs. Got a Type4 cam,Moose Jr. with a smoke puff eliminator, Moose misters, ARP studs.
Here is my rig.
got the block on the table wil get it on the stand when the soft plugs and the cam bearings are done
crank and spare parts swapped in a zf5 last summer now need to get my mt tilt colum in
parts is parts, forgot how mach room engine can take up. Also got the rotating assembly balanced for the 7.3l luk single mass flywheel.
You must be registered for see images attach
Here is my rig.
You must be registered for see images attach
got the block on the table wil get it on the stand when the soft plugs and the cam bearings are done
You must be registered for see images attach
crank and spare parts swapped in a zf5 last summer now need to get my mt tilt colum in
You must be registered for see images attach
parts is parts, forgot how mach room engine can take up. Also got the rotating assembly balanced for the 7.3l luk single mass flywheel.