austin92
Full Access Member
I just completely rebuilt a 10.25 to replace my Dana 61. Waiting for the right time to put it in
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
I am curious, how is the roll on paint job holding up?
I was looking for information about the spindle nuts, are the front's the same? 65ft lbs and back off 1/4 turn?Slowest... brake/hub job... ever... lol
Anyways... hubs are back on. I soaked the new bearings in 75/140 synthetic before installing. I also put a thin bead of RTV on both the inner and outer sealing surfaces of the scotseal (2 piece seal design). Had a bit of pitting and was worried about oil seeping. Spindle nuts torqued to 65 and backed off 5 clicks (roughly 1/4 turn).
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
Should have the housing cleaned and painted/bedlined over the weekend. I'll also be ordering the rest of the little parts to get it swapped in. Slowly making progress...
It'll go faster once the weather warms up and the kid can come out in the shop with me.