Issue that came up yesterday was that the center paper got a bubble, tile checked out to still be straight. Pulling that waight around was a bit of a drag, so tryed without it today and got this far.
-intake rail is around .003 except the ends that are true with spots around .0025
.0025 lone spot center
elsewhere .0025 slides this far that is at the fire ring
and .003 slides this far that is inside the fire ring
Checked how much was cut from the head and is at .0095, Im ignoring one outlier.
-intake rail is around .003 except the ends that are true with spots around .0025
.0025 lone spot center
You must be registered for see images attach
elsewhere .0025 slides this far that is at the fire ring
You must be registered for see images attach
You must be registered for see images attach
and .003 slides this far that is inside the fire ring
You must be registered for see images attach
You must be registered for see images attach
Checked how much was cut from the head and is at .0095, Im ignoring one outlier.
You must be registered for see images attach