Ended up back at that ma and pa store to get a hose made, so picked up a lot of cheap paper.
You must be registered for see images attach
Since the intake side rail is a low, went with block like this pulling end to end. I used a large waight today in an attempt to make a cut.
You must be registered for see images attach
You must be registered for see images attach
Some hours later with many, many, many brakes. I got the last lows to this point.
-red dot is almost mia
-intake rail is mostly down to .003
-right and center are less than .003 except these points that are .003
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
-center slides this far now
You must be registered for see images attach
The amount of pressure that was exerted, I think was bowing the tile because I got a low here now or something was up with the paper. It seems the lows are moving around on me.
You must be registered for see images attach