"93 7.3 N/A need advice no turn over

[Jake60]

@Jake60 no grinder didn't go that far.

At least some sandpaper. With a new starter and a good battery it's a bad ground 99% of the time, either battery to frame or frame to block.

 

[Thewespaul]

You said you replaced the cables, I’m willing to bet either the smaller wire coming from the ground on the core support to the driver side battery ground or the wire going to the frame to engine. Having both or one of these missing will not allow the ignition switch to function. Just ran into this with a truck today.

 

[franklin2]

I thought he said it would turn over, but slowly?

 

[Jason1377]

You said you replaced the cables, I’m willing to bet either the smaller wire coming from the ground on the core support to the driver side battery ground or the wire going to the frame to engine. Having both or one of these missing will not allow the ignition switch to function. Just ran into this with a truck today.

That's been my goal replace that as well positive cable done passenger side negative cable a pain in the ass to do drive side this weekend if there's no rain fresh batteries, new cuss words n life experience