Agreed. Some people refer to it the other way so I thought I'd ask to be sure. lol
Check the routing of your throttle cable. On the drivers side there is a large rubber insulator to prevent direct contact with the injector line (#8). On a stock installation there is nothing on the passenger...
You certainly need to look for the spacer before you put any flywheel on.
Are you 100% sure the old (1993) engine is a "factory" IDI turbo? The turbo may have been installed later on another engine. The serial number on the block (driver's side in front of the IP gear cover) will be...
Justin,
It sounds like you have a tough decision to make.
I still remember when you were posting about the color change... which was a while ago. :D
I will say...
... is NOT something you're going to hear around here very often. :eek: LOL
Good luck in whatever you decide.
That IS the pressure side on the Banks gen 1 & 2.
The gen 1 has the intake hat and airbox cast in two seperate pieces. It has the round edges on the air box lid and uses a 3" tall air filter.
The gen 2 intake hat and air box are cast as a single piece (this is the one 7.3IDI has and the...
The rubber seal goes at the base of the king pin on the top end. This is the best picture I can find right now.
Let us know if you have any more questions.
Al,
Call Pacific Fasteners located in Burnaby (604.294.9411). They have pretty much everything you can think of or they can get it. I haven't dealt with them for a few years but their prices were always reasonable whether I was ordering 10,000 pieces at a time for a production run or 5 pieces...
User tbrumm just bought an all new hydroboost last week- here's the thread: http://www.oilburners.net/forums/showthread.php?62634-Got-my-hydroboost-parts-yesterday! Granted he is converting a 94 but his parts source(s) should be helpful if there is any difference for your rig. There is also an...
Please be careful as the batteries are actually connected in parallel. If they were connected in series you would have 24 volts going to the system. Parallel is + to +, series is + to - and then to the system.
Have the machine shop pressure test the head. That is the only way you're going to find out if there are any other problems. They can only tell so much if they just magnaflux it.
Here's a pic of a 7.3 head that had a lot of machine work done to it by a "reputable rebuilder". Short version of...
The correct plug for the oil line is 1/8" NPT. The one you pulled is further forward. In the pic behind the exhaust is the one you want. The one you pulled is in front of the exhaust in the pic. Once you get the plug out connect the line to the elbow and then put the other end of the line into a...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.