Not sure where to put this but i am swapping a scout D44 into my Jeep diesel project and i am not sure what to do about the knuckles.
1. i have just the scout knuckles themselves (no spindle, bearings or hubs) but the arms coming off them are really long.
2. i have my jeep D30 that looks like the knuckles bolt on but the spindles wont work. not sure if i can get the D44 stub shafts to work with it to.
3. then i also have a TTB set up from a F150 with the bearings hubs and all.
i was hoping that i could swap the complete disk brake knuckles, rotor, spindle etc from the TTB set up i have and be good to go since i have this lying around.
thanks
1. i have just the scout knuckles themselves (no spindle, bearings or hubs) but the arms coming off them are really long.
2. i have my jeep D30 that looks like the knuckles bolt on but the spindles wont work. not sure if i can get the D44 stub shafts to work with it to.
3. then i also have a TTB set up from a F150 with the bearings hubs and all.
i was hoping that i could swap the complete disk brake knuckles, rotor, spindle etc from the TTB set up i have and be good to go since i have this lying around.
thanks