T-19 crossmember pics?

[6.9poweredscout]

anybody have a crossmember pic of a t-19 in a 4X4 f-250? i made a crossmember and had to lower it 1" and raise the carrier bearing 1" to make the rear shaft have a better angle. it SHOOK the shifter bad when i'd pull out, it's ALOT less severe now. i want to see how the front shaft is, with my setup it will fit with the slider at the t-case but there's only about 3/4" between the shaft and the crossmember. i still have the to shorten the front shaft and shorten the rear shaft i got.

also i noticed the mount for the t-19 is about 1" off center to where the auto trans was, this is normal right?? and is it normal for the shifter to shake a bit when pulling out?

thanks for the help again guys this site is amazing!!!
-Jon

 

[sle2115]

I can get you some pictures tomorrow, what do you want to see? Dark here now, and raining!

As for the shake, I find if I don't touch or hardly touch the shifter when releasing the clutch, mine does it much less, but if you drive it like a gasser (apply throttle when releasing clutch) mine will have a little shake as well. Getting ready to re-clutch and will probably throw a new set of motor mounts on it as well.

 

[82F100SWB]

This is a 460 truck, but the crossmember is the same:

You must be registered for see images

Hope that helps.

 

[6.9poweredscout]

ahh it does drop down by the shaft.... hmmm. also does the trans mount sit flush with frame or sit below it a little, i had it flush but tried to lower it 1" to see if it helped with the shaking, minor help, may remove the shims. i think the better angle on the carrier helped the most.

thanks
-Jon

 

[6.9poweredscout]

before i made the dropdown.