oil for turbo

[86F2506.9]

ok where is the best place to run my oil feed line on the block if you can pictures plz

 

[BlueBreadTruck]

right behind the CDR grommet slightly to the left where the oil pressure sensor is

 

[icanfixall]

Depends on what turbo you are running. The recommended location for the Banks turbo is just back from the oil filter on the bell housing flange web. Don't try to use any of the plugs in the rear oil cooler header. All those are unfiltered oil.

 

[RLDSL]

Make sure to clean out the hole before you thread a fitting in so you don't feed your turbo a belly full of carbon plug.

 

[86F2506.9]

its the ats non wastegated

 

[RLDSL]

its the ats non wastegated

On mine I just put in a T fitting for the oil pressure sender at the back of the block with a leg for a -6 AN hose attachment and ran an aeroquip hose up to the turbo. The 088 is threaded so I just got an adapter for that end as well.