So... with the engine basically out including rad support. The interior out, and tranny out i have a lot of parts laying around. I took pictures and documented as much as I could. However i feel like no amount of documentation would have sufficed to create the perfect guide to putting everything back. Especially considering the age of the truck and the various previous owners jerry rigging stuff. I have a lot of bolts. Is there a guide to what goes where. I want to do it by the book, problem is there isnt a "book" as far as i can find. Any recommendations on this? Barring i try to go find these nuts and bolts at the local hardware store. I seen bronco graveyard selling some pricey stainless fastener kits. Almost feeling desperate enough to spend the money just because their bags are labeled. Thank you in advance!
Also what thread locker does everyone prefer? loctite, teflon, gasket sealer, etc?
Also what thread locker does everyone prefer? loctite, teflon, gasket sealer, etc?