Jesus Freak
Full Access Member
So eventually I'll start a thread for my tow truck but I wanted to show case this since I was working on my fuel cells right now. I asked about "shower heads" a while back and got a mixed review of replacing them so I decided to go with an idea I had for my dually when I put a bronco tank on it. So its pretty self explanatory looking at the pictures, the only piece that might not be obvious is the corrugated fuel line I found on Amazon. It's 10mm on one side, 9mm on the other side, and it's 160mm long. I squeezed the 9mm side over the 5/16 barbed fitting and clamped the mess out of it on the sending unit. I'm not sure what the micron rating is but it's fine. I lined the brass fittings up and have them set to lay down nice on the tank bottom. Gimme some feedback! Whaddya think? Is it good? Or is it "FREAKY"? Sure wish Bart could chime in.....