Keep or replace oil pump during rebuild?

MasterChiefIDI

Registered User
Joined
Mar 20, 2025
Posts
74
Reaction score
61
Location
Mississippi, USA
Is the general consensus still to reuse the original oil pump during a rebuild or should it be replaced? Mine turns over smoothly and is clean. There is some wear on the impeller blades but does not seem bad. Can fit a ~.012"-.013" feeler between the impeller blades. What do y'all recommend in this area?

Thanks
 

Clb

Another old truck
Supporting Member
Joined
Mar 1, 2013
Posts
6,993
Reaction score
3,388
Location
nannyfornia
I don't know if the prevailng mindset here is a worn oem pump is superior to a chiacom offering, so I'm going to say...

Common sense used to require a new pump, although it died long ago..
Ymmv :cheers:
 

MasterChiefIDI

Registered User
Joined
Mar 20, 2025
Posts
74
Reaction score
61
Location
Mississippi, USA
I guess I feel kind of dumb even asking the question.. I ask just to make sure not wasting $275 and because of reading previous threads on here like the one below:

Oil pressure, is there a better pump | Page 2 | Diesel Truck Forum - Oilburners.net https://share.google/uwn8ihknUggo1TDxQ

I have a new melling oil pump in mine, and if I ever need to drop the pan I am going to put the original IH one back in.
the melling was so far out of spec I almost didnt use it. had to sand the housings to get minimum gear clearance.

There is no hi volume pump for these and I would have to say dont use a new one unless yours is trashed.

Oil pump, unless it looks/feels like it was damaged, is going to be fine. They don't generally wear out, and the factory ones are better than new aftermarket anyway...

It pumps so much oil as it is that a little leakage isn't going to affect anything. Low oil pressure at idle is caused by a sticky relief valve in the oil cooler, not (generally) an oil pump issue.

That being said, 10 psi at hot idle is 'fine'.
 
Last edited:

Black dawg

Registered User
Joined
Jan 9, 2006
Posts
4,497
Reaction score
1,064
Location
sw mt
There was a time when the replacement pumps provided much lower pressure than a several hundred miles old pump. Everybody started just re using the old pump.
I would just check it out good. If it looks good, run it.
 

Latest posts

Forum statistics

Threads
93,042
Posts
1,156,401
Members
26,636
Latest member
bjujnovich

Members online

Top