Interesting IDI glow plug harness listed on eBay

[tbrumm]

I saw this glow plug harness listed on eBay and the "bullet connectors" seem really beefy - never seen ones like that before. http://www.ebay.com/itm/181939762632?_trksid=p2060353.m1438.l2649&ssPageName=STRK%3AMEBIDX%3AIT
Has anybody else seen connectors like this or know where to get 'em? I contacted the seller and have not heard back yet, but he may not want to divulge his source.

 

[laserjock]

That is a sweet looking setup.

 

[laserjock]

Quick search turns those up as a GP connector for a 6.0. Looks like he took a 6.0 harness and cut the plugs off and swapped on ring terminals.

 

[tbrumm]

Thanks for your research, Laserjock! Those terminals certainly look like they would do the job. As large as those terminal are, they might be a little tight around the injectors and lines. I'll have to do a little more research.

 

[79jasper]

Hmm, I thought it looked like a 6.0 harness for some reason. Lol

Sent from my SAMSUNG-SM-G890A using Tapatalk

 

[outtowinpahc]

you you can use the correct nut and all ring terminals with a vac cap over the protruding stud.... cost is about 8 bucks this way

 

[tbrumm]

you you can use the correct nut and all ring terminals with a vac cap over the protruding stud.... cost is about 8 bucks this way

Good idea on the vacuum fitting over the bullet terminal. Here is another terminal cover that may work that was used on the Hummers.http://www.ebay.com/itm/HUMMER-HUMVEE-HMMWV-M998-GLOW-PLUG-BOOTS-LOT-OF-8-/350275972393?hash=item518e132d29:m:m_EFpvY8AwyXiXrY4hgi_hw&vxp=mtr

 

[laserjock]

Those things (the OP) look like push to connect plumbing fittings. They even sell a tool to pull them off that looks like something you would use to separate them.