high idle plunger

[kbenz]

Mine is gone. not sure what happened. I ran a magnet through the valley pan best I could and turned up nothing. Where and what am I looking for as far as getting another one?

 

[Black dawg]

That piece just screws into the solenoid, probably just backed out. Probably back by the valley drain area if the pan is pretty clean

 

[Rocknit4x4]

CDD and Russ Repair occasionally have used ones - not sure where you could get a new one - I tried a few universal ones before I knew about oilburners and the reputable vendors for our trucks with no success.

 

[kbenz]

any idea what the thread size is?

 

[kbenz]

That piece just screws into the solenoid, probably just backed out. Probably back by the valley drain area if the pan is pretty clean

I ran a magnet up there best I could but came up empty

 

[franklin2]

In my opinion it's not worth the trouble to replace it. Mine has not been hooked up for years. It runs fine without it.

 

[Black dawg]

I ran a magnet up there best I could but came up empty

I will look tomorrow. If I have one, I will send you one.

 

[Black dawg]

So I looked, and none of them I have will unscrew all of the way....get really hard to turn.

 

[IDIBRONCO]

So I looked, and none of them I have will unscrew all of the way....get really hard to turn.

That's what I was thinking that they do.

 

[kbenz]

So I looked, and none of them I have will unscrew all of the way....get really hard to turn.

so maybe it broke? guess I need to just pull it off and see

 

[Black dawg]

It might have broke, but It seems line I have seen some that would thread all of the way out.