I am about to install a 3 gauge pod with Boost, Water Temp and Pyro, the boost is easy as the 94 has a port in the intake hat, or snail shell. The water temp is hidden to me but I believe there is a port on top of the intake or block for the normal water temp sensor, I should be able to tap into it, if I can find it. Does anyone have a good pic or description of the port or is there an easier one to use?
The pyrometer is another concern. I have normally seen them on the drivers side exhaust manifold where it was drilled and tapped from the bottom. I have also looked at numerous installs online and they all have been from the bottom. I do not believe I will be able to get a drill in there to drill it and if I did then tapping is going to be a real pain. The passenger side is also tight with the exhaust in the way. Is there any reason not to tap the top which is very easy to get to? Obviously I don't want to tap the joint but I should be able to do either side of the casting joint, or is it ok to grind a flat spot on the joint?
This is the top drivers side, plenty of room.
This is my first time to do this so any tips would help greatly.
Thanks,
Jack
The pyrometer is another concern. I have normally seen them on the drivers side exhaust manifold where it was drilled and tapped from the bottom. I have also looked at numerous installs online and they all have been from the bottom. I do not believe I will be able to get a drill in there to drill it and if I did then tapping is going to be a real pain. The passenger side is also tight with the exhaust in the way. Is there any reason not to tap the top which is very easy to get to? Obviously I don't want to tap the joint but I should be able to do either side of the casting joint, or is it ok to grind a flat spot on the joint?
This is the top drivers side, plenty of room.
You must be registered for see images attach
This is my first time to do this so any tips would help greatly.
Thanks,
Jack