-
-
Rrwk replied to the thread FS Dana 60 front axles.yes, PM me
-
Rrwk replied to the thread Stock radio not working.I sold my Craig 8 track player and my few 8 tracks and bought a cassette when they became popular! Can't remember the cassette brand tho!
-
Rrwk replied to the thread FS Dana 60 front axles.Yes, NE of Battle Creek
-
R2 Dana 60s, 93 casting date, 3.54 gears, hubs work, $300 each, will load.
-
-
Rrwk replied to the thread So what did you do with your truck today?.Air cooled engine, need to pull shrouds off and clean cylinders and heads of debris if it has been setting a long time.
-
Rrwk replied to the thread Replacing suspension.Had to cut bolt's on front spring rear mount, pics are of a leaf spring front end with Dana 60 axle, shocks bolt right up, not rear. Try...
-
Rrwk replied to the thread Replacing suspension.Timbrens also, may have to extend them tho, think they should touch stop or almost touch.
-
Rrwk replied to the thread Replacing suspension.Just put new stock leaf's, track bar bushings and yellow Bilstein's on this D60, grease zerk in rear spring bolt, had to cut OG bolts...
-
-
Rrwk replied to the thread Hot hot should my e4od run?.According to Hayden coolers website 180 is a good operating temperature, cooler thick fluid doesn't lubricate or flow as well, most oil...
-
Rrwk replied to the thread Diff covers..Aeriation is a vital but overlooked property of oil, always creates heat if too much, in hydraulic usage it becomes critical. Small...
-
Rrwk replied to the thread So what did you do with your truck today?.Here's a better pic of turbo flex plate with counterweight, must have been that extra Moose pump HP that did it in ;) !
-
-
Rrwk replied to the thread So what did you do with your truck today?.Putting this truck back together, ft. trans seal went out, found flex plate was trashed may have contributed to demise. New R&D HD turbo...
-
-
Rrwk replied to the thread Track bar bushing.Got it, loosed frame track bar mount a bit and did come along again from a different angle, truck weight still on axle.
-
Rrwk replied to the thread Track bar bushing.Yes going to try that next, I went from dr knuckle to pass spring. But there is only so much clearance in axle spring pin holes, and...
-
Rrwk replied to the thread Track bar bushing.yes, did the full weight thing first, then compressed spring with floor jack further, as stated earlier that got the most movement, half...
-
-
Loading…
-
Loading…
