middaymidnight
Registered User
Tired of leaky unreliable mechanical lift pumps. Any one on here replace theirs with one of these, and if so, how reliable has it been.
Facet duralift pump reliability
- Thread starter middaymidnight
- Start date
Had mine for about a year and a half. 16,000 miles or so. It's still clicking along, and when you buy one, you will know what I mean by clicking! It is a solenoid operated diaphragm pump....so it clicks.
sjwelds
Full Access Member
i have one. like it. make sure to get the right pressure. too much is worse than not enough....
yes it does click. you'll soon be listening for the click as you heat the glowplugs prior to engine start.
yes it does click. you'll soon be listening for the click as you heat the glowplugs prior to engine start.
brokeasajoke
Registered User
One of the best upgrades i have done. Nice clear bowl to see fuel and any nasties that may have settled out of fuel.
Works perfectly, mine has been installed for two years now.
iv got one on each of my heavy hauling sob's.
i didn't use either of my trucks for a single day with a oem mechanical.my mama didn't raise no fool.
i didn't use either of my trucks for a single day with a oem mechanical.my mama didn't raise no fool.
middaymidnight
Registered User
Would anyone be kind enough to give me a part number for the exact pump model I need?
gandalf
Senior Member
Here is a picture of mine. The part number is there. These are used extensively on OTR trucks with refer units. Those trailers must stay cold or the load spoils. These pumps feed the cooler units for the refers. If they're not reliable the trucks companies wouldn't rely on them. They run day and night on those refers.
And more numbers on the side, just in case the other is a Carrier number.
Attachments
Pureford
Registered User
I've had mine for two years it was money well spent my trick sits all week and it definitely helps with starting compared to mechanical pump
middaymidnight
Registered User
What should the maximum shutoff psi be?
middaymidnight
Registered User
Would the one with 9-11.5 psi work ok?
marmot
On the bench
40222 or 40223 are the facet numbers, napa has them I will try to find the napa part # I have it somewhere. If you stop by napa ask for a fuel pump for a thermoking ******, and then have them check the facet website. or you can rock em on ebay,
http://www.ebay.com/itm/141311092847?_trksid=p2060778.m1438.l2649&ssPageName=STRK%3AMEBIDX%3AIT for a bit less money. The seachoice branded 40222 seems to be the cheapest.
http://www.ebay.com/itm/141311092847?_trksid=p2060778.m1438.l2649&ssPageName=STRK%3AMEBIDX%3AIT for a bit less money. The seachoice branded 40222 seems to be the cheapest.
middaymidnight
Registered User
My company gets a good discount at Napa so it may be cheaper to get it from them but thanks a lot for the link
marmot
On the bench
NAPA BK.610-2400
