'92 vs '93 fuel heater o ring part # and glow plug questions

[buickman69]

I read this thread by Exekiel69:
http://www.oilburners.net/forums/showthread.php?46363-Fuel-heater-O-ring-replacement
He posted a International part # of 1811053C1.
After reading his thread Friday afternoon I called my local International stealership and ordered 3 rings, (2 for spares)

Yesterday was watching Youtube videos and decided to go take mine apart. Mine is different from Exekiel69. Apparently there is a difference in '92-'93?

Mine is identical to the one in this video:
https://www.youtube.com/watch?v=M6ILnpNCxu8&x-yt-ts=1421914688&x-yt-cl=84503534
In the comment section someone post the Napa part #s BK 727-2014 and BK 727-2016.
In the video dude shows there is 2 o rings, one on the lower part of the heater and one on the upper part.

Am I safe to assume I need the 2 Napa o rings and should cancel the order for the ones from International or are they all the same?

Also is ZD-9 the correct glow-plug Motorcraft part number for my '92 IDI?

I don't want to remove the heater and plug the hole, and don't care if it works, just want it to stop leaking. Thanks.

 

[towcat]

post a pic of yours. there should be only one version.
the glowplug p/n is right.

 

[buickman69]

You must be registered for see images attach

Try this one

 

[buickman69]

Sorry
will try again

 

[buickman69]

post a pic of yours. there should be only one version.
the glowplug p/n is right.

You must be registered for see images attach

Finally... sorry bout the wrong pics

 

[towcat]

yours is no different. he just completely tore his down.
i cheated. i just shoved a bob of JB weld on top where the connector port is at.

 

[buickman69]

yours is no different. he just completely tore his down.
i cheated. i just shoved a bob of JB weld on top where the connector port is at.

Oky doke. Thanks.