I’m really thinking about doing a DT360 swap on this truck and just redoing everything. I’m just not sure if what’s involved in swapping out the 6.9 for the DT360. I just figured if I’m going to take the dash out why not just change out everything. When I got the truck that was the original plan and I located a DT360 in a 1992 bus just wondering if I should pull the trigger on this project. Any suggestions are greatly appreciated.
6.9 idi wiring harness
- Thread starter Trucker73
- Start date
Cainon
Full Access Member
Did wiring a toggle switch for the fss work? I might try that with this one. Some wires melted. I sniped and patched them but no luck.
