Search results

  1. ISPKI

    Driver side door stuck !HELP!

    This is not so much a diesel discussion as much as it is an OBS question. The driver side door on my 94 is jammed closed. I was leaving a job site in my truck and the door wouldnt close on the striker. Known issue, has a new striker and I dont have it aligned quite right. Didnt really have...
  2. ISPKI

    Overhead Gauge Cluster

    So ive been doing some electrical work on my Slug, adding gauges for the turbo system and what not. I have always kind of disliked the pillar pods that people normally use and I have always liked the idea of the overhead wooden consoles made by Centurion. Well, I have an ancient bridgeport mill...
  3. ISPKI

    Figuring out best place to wire these gages

    I am installing some gages in my 94 superduty. Pyrometer, Oil Pressure, Boost, maybe a couple others. I was wondering about a good place to pull switched power. I ran a 16ga wire (Green wire with Red heatshrink on the end) to a fuse block under the dash to provide what I believe is switched...
  4. ISPKI

    Glowplug issue just in time for winter

    Hey all, of course Good ole' rusty-but-trusty had a hiccup as soon as it starts getting cold. Went to head over to my uncle's last week to take down a tree aaaaaand glow plug controller just clicks with no prime. Started troubleshooting over the weekend. Started by pull the GP wires off and...
  5. ISPKI

    Accelerator Cable replacement

    Hey all. Just did a bunch of fuel line work on my Slug over the weekend. While working on it, I noticed the accelerator cable plastic sleeves are shattered and cause the cable to jam constantly. Figured I would deal with it while im working on it. I found these two parts on Rockauto but they...
  6. ISPKI

    Random surging while driving

    Mornin' folks. Just had an issue come up with 94: While driving the truck will surge a little bit, acting like I suddenly hammered the throttle down. Usually lasts a handful of seconds and then goes back to it's normal sluggish self. Seems to happen once the truck is warmed up a bit, as in, it...
  7. ISPKI

    7.3 bottom IP bolt

    Hey all. I finally made a wrench that could get to that bottom bolt on the IP head to adjust my timing. When I went to loosen it, it was not tight. Went and loosened the other two bolts, adjusted my timing about 1/16" towards passenger side (was at 4.0 BTDC, now at 9.2 BTDC). I pinned the IP in...
  8. ISPKI

    Amsoil Injector cleaner

    Has anyone used Amsoil's diesel injector cleaner/cetane booster to clean up injectors? Any idea if it helps at all or if its just snake oil? Got a local Amsoil guy I might line up my next oil change with and hes asking if I want to throw in some other products.
  9. ISPKI

    E4OD TC engagement

    Hey all. I want to learn more about the functionality of the E4OD that came in these trucks. I have an E4OD that was supposedly rebuilt or serviced in 2014 in my F-SuperDuty. I separated it from the motor to replace the flexplate due to the starter not being fully mounted and chewing the teeth...
  10. ISPKI

    Easy Fuel Additive system

    Hey all, So I have a wide flatbed on my IDI in my sig and it is a pain in the rear to add fuel additive from the jug into the tank when im filling up. I was wondering what people did about this. Trying to work up a method to eliminate spilling. What I have been looking at us splicing a barbed...
  11. ISPKI

    Ignition actuator rod replacement continued

    Hey all. I am at a complete loss. The steering column is built like a labyrinth that's not intended to come apart and I am stuck. See attached. I've stripped my column down as much as I can but I can't get the new actuator rod installed. It doesn't fit and the nylon piece in the column seems...
  12. ISPKI

    Ignition Switch Actuator Rod replacement

    Hey all, Ignition actuator rod arm thing in the column broke yesterday and I am having a helluva hard time trying to find any instructions on how to replace it. Truck is a 1994 F-Superduty with a non power non tilt steering wheel. I *think* I have to take the steering wheel off but the darn...
  13. ISPKI

    Trailer Harness electrical

    Hey all, So I got my 94 F-Superduty earlier this year and have been having a great time stocking up on firewood for this coming winter. The truck has an extremely heavy duty bumper/tow hitch setup and I would like to setup a trailer harness and controller for the truck so I can start hauling...
  14. ISPKI

    E4OD Behavior

    Hey all. I have been noticing some odd behavior from my E4OD in my 94 F-Superduty. Transmission shifts great smooth but solid all the way up to 4th gear. Heres where the odd behavior starts. If I press the throttle fairly hard, say accelerating on the highway to pass a slow driver, it seems to...
  15. ISPKI

    Fixed headlight knob

    Hey all. Every OBS I have ever owned has had the headlight knob broken off, my new super duty is no exception so I am making a permanent replacement. Knob is 303SS. Drilled and threaded for 3 serrated 8-32 steel set screws. Going to drill and thread it today after work with a spin indexer...
  16. ISPKI

    Headlights...I cant see diddly squat at night

    As the title says, the headlights in my slug - Earl Simpson Sr. are spanked. I was driving home with a load of ash last night and realized it was the first time I had driven the thing at night and I didnt like it one bit. That being said. What is everyone's opinions on headlights? Any...
  17. ISPKI

    94 F-Superduty Tail lights

    Hey ya all. I am just about ready to mount my flat bed onto my new F-Superduty. Its a 94 7.3idi. I searched around for a few pages but wasnt seeing anything clear for a cab and chassis. The back of the electrical harness was cut and spliced and yadda yadda back at the rear of the truck...
  18. ISPKI

    Cab and Chassis Tail lights

    Hey ya all. I am just about ready to mount my flat bed onto my new F-Superduty. Its a 94 7.3idi. I searched around for a few pages but wasnt seeing anything clear for a cab and chassis. The back of the electrical harness was cut and spliced and yadda yadda back at the rear of the truck...
  19. ISPKI

    Interesting gauge mounts

    Hey all, I am installing a pair of pyrometers in my 94 superduty (I salvaged two banks dynafact guages from junked trucks for super cheap). I dont really like the pillar gauge pod setup, they seem to be cheap and dont mount nicely whenever ive installed them. Who has seen or done it...
  20. ISPKI

    Bracket on rear of F Superduty Dana 80

    Hey all. I was cleaning up the underside of my 94 F Super duty prepping to flush out the rear axle and I noticed an odd looking bracket assembly bolted to it. There is a steel bracket bolted next to the rear diff cover. That bracket has a sort of pivot pin with a banana shaped bar leading to...
  21. ISPKI

    Exhaust pipe seals

    Hey all, So I recently customized my collector pipe to adapt up to a 4" oval transition to 4" Round pipe at the "Y" joint where the pipes are welded together. What do you all use to seal the flange connection to the manifolds? I used a couple donut things I had in my toolbox but they were a...
  22. ISPKI

    Stuck FIPL

    Hey all, So I just replaced the FIPL on my 94 superduty. The larger torx screws were jammed in there pretty tight and I ended up break a 1/4" ratchet a cheap T27 torx drive bit and a T27 Torx L key. Barely managed to extract the screw using a 3/8" ratchet with a 1/4" adapter and a Wiha brand...
  23. ISPKI

    Truck starting issues, not the usual

    So my "new" F-Superduty has this intermittent issue where the starter seemed to be not engage fully sometimes, causing it to make that horrific wine as the teeth spin by without engaging the flexplate. Starter looked old so I bought a new powermaster unit and installed it yesterday. Found that...
  24. ISPKI

    Long shot, E4OD Flex Plate in CT

    Kind of a long shot but is there anyone in CT who has a Flex plate laying around for an E4OD? Specifically for a 7.3 N/A IDI? I dont know if the turbo ones or the 460 ones are actually different.
  25. ISPKI

    Dont get mad, spiked lug nuts

    Hey all, I have been working on cleaning up my 94 super duty idi and the lug nuts look to be in sad shape. The rears are OK looking on one side, crusty on the other, missing one. The fronts look miserable, missing alot of the chrome caps, some of them have two regular nuts double stacked on...

Latest posts

Forum statistics

Threads
92,997
Posts
1,155,967
Members
26,584
Latest member
Bria007

Members online

Total: 735 (members: 6, guests: 729)

Share this page

Top