turbo heat shields

[ironworker40]

Does anyone have a picture of a ats 093 turbo with the correct heat shielding that came with it for the firewall, evaporator box, etc. I want to re-do mine and would like to know what is supposed to be there. Also were can it be purchased?

 

[vandy7.3]

Ats no longer makes parts for these turbo systems. So unless you have all of that stuff you may be SOL. I have most all of the factory heat shields they are a little bent up but I didn't use them when I put the turbo on my truck. I just exhaust wrapped everything and bought a turbo blanket off eBay.

Sent from my SCH-R890 using Tapatalk

 

[ironworker40]

Mine only has 1 piece of heat shielding behind the pipes against the firewall. No blanket on turbo. nothing on heater box I wanted to see what they came with so I can replace what if anything is missing

 

[turbo elk]

All mine has is a little flap of metal to shield the fuel line to the rear cylinder.

 

[vandy7.3]

I cut more insulation off my truck than I put on when I installed my turbo. It's an xlt lariat, the entire fire wall had insulation had to get rid of it all to fit up pipe and down pipe. But I did wrap all my exhaust components. Should be good enough

Sent from my SCH-R890 using Tapatalk

 

[Agnem]

Honestly, you will be fine if you don't wrap anything.

 

[GENIUSLOERTS]

Honestly, you will be fine if you don't wrap anything.

TWSS.... Sorry, I couldn't let that one go by.

 

[jaluhn83]

I got something like this:
http://www.ebay.com/itm/Thermo-Tec-...Parts_Accessories&hash=item3a81d51a4d&vxp=mtr
but a cheaper knock off - can't find it in the 30 seconds of searching but it's the same idea.

I used it to wrap the up&down pipes and turbo hot side. You may not need it, but I like the idea of having some insulation there. It can hold moisture though and accelerate rusting though if you're somewhere that's an issue.

 

[kendawg69a]

Have a 94 stock turbo I could snap picks of for u if you want?

Sent from my SCH-I605 using Tapatalk