How's this for bumpers?!

[6.9poweredscout]

i got my bumpers painted and installed. the front had a smasher/winch cradle. eventually i'll fill it with a winch! the rear has 2 end cap protection posts and an 1 and 1/4" u bolt off an tri axle plug welded and welded around to it (for pulling jeeps! ).

-Jon

http://www.facebook.com/photo.php?pid=328463&l=7c08782f1b&id=100000016924098

http://www.facebook.com/photo.php?p...28462&id=100000016924098&fbid=124980110845886

 

[88beast]

dont diss jeeps mines getting a 73 and t19 well then its got more ford by weight hum wonder what makes a vehicle its brand weight total components or the badge?

 

[crashnzuk]

If you hit those corner posts on something, they will hit the body. Just sayin'
Travis..

 

[rjjp]

dont diss jeeps mines getting a 73 and t19 well then its got more ford by weight hum wonder what makes a vehicle its brand weight total components or the badge?

Actuly that would be more International Harvester by weight.

 

[6.9poweredscout]

If you hit those corner posts on something, they will hit the body. Just sayin'
Travis..

1/4 inch wall on the bumpers, 5/16ths mounts, practically solid posts, the holes were cut the posts put through the bumper and welded on the sides too....how would that work??? haha my friend has the same setup on his scout with SOLID posts and they're alot closer to the body than mine, he's smacked many trees and they've never come close to touching.


-Jon

 

[MIDNIGHT RIDER]

2nd link comes up blank for me.

 

[6.9poweredscout]

Hmmm should be able to navigate to it from the first picture? Its of the front bumper.

-Jon

 

[jwalterus]

doesn't work for me either

 

[Alex S]

I like it! a filler between the gate and the bumper would make it perfect, maybe diamond plate

 

[freebird01]

i was gunna say not bad but its a bit on the square side...but the whole truck is a big square lol.


will deff take a beating thats for sure. im not sure i like the posts hangin out there myself either but if you like that thats all that matters

 

[crashnzuk]

Sounds pretty stout then. If your buddy hasn't had any problems, I guess go with what you know. Why the body lift? Was it necessary for the engine/trans combo I didn't read your whole build thread.
Travis..

 

[6.9poweredscout]

the body lift was a combo of more engine clearance and more room to clean the frame. oh and the added wheel clearance helps!

-Jon