gear vendors overdrive

[c_silva88]

i have a a 1345 with gear vendors over/underdrive unit complete with all the wiring and every thing to install it shifts smooth looking to get $1000 obo . will trade for a complete turbo set up for a 6.9 with a zf behind it

 

[tjsea]

Can you post some pics?

 

[c_silva88]

its still in my truck im swapping in my 5 speed in this week

You must be registered for see images attach

 

[junior20762003]

will this work on a 4x4 e4od

 

[c_silva88]

will this work on a 4x4 e4od

from what i've read the e4od and the c6 share the same tail housing extension so i see no reason why it would't work

 

[towcat]

this GV unit will work behind any 4wd trans. all it cares is that the transfer case is ideally a BW 1356. why? the BW 1356 has a removable tailcone. if it is a BW 1345 unit, then you will need the back half case casting as shown in the pic or find your own 1356 back housing.
hope this helps clarify things.

 

[performancelaw]

So it'll work on the zf 5 with the bw1356. Damn I wish I had the money !

 

[alienturtle]

So it'll work on the zf 5 with the bw1356. Damn I wish I had the money !

Correct. When it comes to gear vendor units when bolted to a 4X4, The tranny does not matter. It only cares what its getting bolted to. In a 4X4 that is the T-Case. In 2wd form that is the tranny

 

[sle2115]

To the OP, I don't think that transfer case is a 1345 either, the 1345 uses the whole rear cover as the adapter for a GV unit. That looks to be a 1356 as Towcat said.

 

[gonecrazyi]

Its a 1345. The case is stamped gv and the speedo cable is cast into the t case tail housing

 

[6 Nebraska IDIs]

Sent you a PM about this.

 

[c_silva88]

bump

 

[giezy]

so will this bolt to a trans that is 4wd and be used as a 2wd trans?

 

[6 Nebraska IDIs]

No you have to use the transfercase.

 

[c_silva88]

ttt