DOes anyone have or knwo the size of the O ring or gasket which goes behind the lemon cover on the timing gear housing? 3rd time tryign to reseal with RTV and still get a bit of blowby past it even after curing overnight. Probably some contaminants left over on the housing that im not able to clean off too well.. Just want to stick the O ring in there and call it a day.
gasket/ or ring for lemon timing cover?
- Thread starter Greg5OH
- Start date
http://www.mcmaster.com/#o-rings/=13jbe57
I think they are nominal 0.1" Its a dash 144 o-ring. That should get you all you need to know. Dash sizes are standard. Seemed to fit good. I put a couple dots of RTV on the groove just to hold the thing in place while I tightened it up. Wouldn't stay in the groove while I was getting the other stuff together.
I think they are nominal 0.1" Its a dash 144 o-ring. That should get you all you need to know. Dash sizes are standard. Seemed to fit good. I put a couple dots of RTV on the groove just to hold the thing in place while I tightened it up. Wouldn't stay in the groove while I was getting the other stuff together.
Similar threads
