DMcV
Registered User
Hello,
New to post , but I've been reading and learning on this Great Forum.
My (new to me) truck came with an 'Edge Evolution' programer.
I have the operating instructions but before I start to play with any of the settings I though I should ask first . I will be using the truck to tow my 5th wheel on vaction times but I also tow a small enclosed steel box work trailer (weight unknown) but it does carry a good load.
My question is would the :
1) "tow" power level ( 60hp gain, 110 Tq gain) be a good level to use for both ? anything that I should be aware of ?
2) any harm if I leave it in "tow" setting while not towing ?
3) what are the 'most important' PID's that I should have displayed ?
Sorry if this sounds at all "naive"...it is only because I 'am'
Thank you
Dennis
New to post , but I've been reading and learning on this Great Forum.
My (new to me) truck came with an 'Edge Evolution' programer.
I have the operating instructions but before I start to play with any of the settings I though I should ask first . I will be using the truck to tow my 5th wheel on vaction times but I also tow a small enclosed steel box work trailer (weight unknown) but it does carry a good load.
My question is would the :
1) "tow" power level ( 60hp gain, 110 Tq gain) be a good level to use for both ? anything that I should be aware of ?
2) any harm if I leave it in "tow" setting while not towing ?
3) what are the 'most important' PID's that I should have displayed ?
Sorry if this sounds at all "naive"...it is only because I 'am'
Thank you
Dennis