Cruise control

[79jasper]

I swapped in a tilt/cruise wheel, hooked everything up, jump the brake cutout switch, and currently am not getting cruise.
The horn works.
Truck previously did not have cruise, but was told get the button pad, and you're good to go.
My center mount brake light is not coming on, don't think it ever did, don't even know if it's actually hooked up. Going to replace the bulb tomorrow and see if that fixes it.
Also going to check the clutch switch.
Anything else to look at?

Sent from my SM-G900R4 using Tapatalk

 

[theguruat12]

Test the speed sensour. That went bad on my truck, frying the t-case speedo gears. Plus, cruise no worky

An ohmmeter across it should read at around 180-240 Ohms. 0 or inf. signals bad sensour.

 

[79jasper]

Only one I have is in the rear.(94)
I have noticed my speedo is slightly bouncy sometimes.
I'll pull it and make sure there's nothing on it.

Sent from my SM-G900R4 using Tapatalk

 

[theguruat12]

Ah lolol my bad, I always forget to check sigs.

 

[79jasper]

And this is in the psd section. Lol

Sent from my SM-G900R4 using Tapatalk

 

[79jasper]

But to update, I've checked wiring, replaced the 3rd brake light, and still no cruise.

Sent from my SM-G900R4 using Tapatalk

 

[94f450sd]

I believe you need a pcm that has cruise.

 

[79jasper]

Hmmm.
I'll have to see if I can find one.

Sent from my SM-G900R4 using Tapatalk

 

[oregon96psd]

Ive always been told that you have to put the horn pad and a fuse in them to get cruise, nothing about jumping a switch. Check the fuse panel and see if theres a place for a fuse?

Edit: Looked it up on powerstroke.org and you should be good to go. Don't know where I got the idea about the fuse.

 

[79jasper]

It's supposed to be the same one for something else, but I'll double check.

Sent from my SM-G900R4 using Tapatalk

 

[79jasper]

Just to update, when I was having the no start problems, I found a fuse to be blown. Was for cruise and a few other things. Went on my way heading to elpaso, got like halfway there or more and just randomly decided to try the cruise, works great. Lol
I was certain I had checked it before. Who knows.
Also I just have the brake pressure switch (at the master) jumped since mine doesn't have it, and the brake cutout works fine also.

Sent from my SAMSUNG-SM-G890A using Tapatalk