i recently installed a sidewinder kit on my 94 IDI. I also replaced gaskets due to leaks, so the engine was out. Now after reinstalling everything, and with new Fox glow glues and a new controller it seems like my wait to start is reading backwards. When it is cold the light flashes once as the key is turned and goes out. I can hear the controller cycling. Starts very hard. Usually have to give it a small squirt of starting fluid.
When it warms up and I shut it down, I go to restart and the light will stay on and it fires right up. One manual I read says that the white wire on my relay should be a ground but it seems to have ignition power.
Module bad?
When it warms up and I shut it down, I go to restart and the light will stay on and it fires right up. One manual I read says that the white wire on my relay should be a ground but it seems to have ignition power.
Module bad?