LCAM-01XA
Full Access Member
This is a front D60 with 3.54 gears. Gears were used but appear to be in good condition. Like a moron I pulled the factory 4.10s out before painting them so I have no idea what their contact pattern looked like... This is what I have now, pics actually show three different groups of painted teeth.
Drive side:
Coast side:
Are these acceptable contact patterns? 4x4 will be used quite rarely and I doubt it will ever see speeds of even as much as 35mph. Factory 235/85-16 tires, no rock crawling or Jeep climbing intended.
Also while we're at it, look at these axle seals - are they in far enough? They kinda look like they're not all the way in, but then again I may just be paranoid (ignore the grime, it has since been cleaned off):
Drive side:
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
Coast side:
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
Are these acceptable contact patterns? 4x4 will be used quite rarely and I doubt it will ever see speeds of even as much as 35mph. Factory 235/85-16 tires, no rock crawling or Jeep climbing intended.
Also while we're at it, look at these axle seals - are they in far enough? They kinda look like they're not all the way in, but then again I may just be paranoid (ignore the grime, it has since been cleaned off):
You must be registered for see images attach
You must be registered for see images attach