leojr
Full Access Member
Any pointers?
Pointers are from someone that has done this...I haven't. But I have an idea?
Make a plate (1/4" or 3/8"?) that fits under the under the passenger's side U-bolt nuts, make the plate long to the rear, and weld your track bar mount to it.
If you had a press you could bend the end 90 degrees for half of the track bar bracket, weld a plate for the other half.
Also, you could mount the track bar to the top of the plate. Every inch you raise the axle end is just like lowering the frame end the same amount.