1994 ttb 50?????

[Nazty 4x4]

Will a dana 50 ttb hub, rotor, bearings and locking hubs fit on a dana 60 spindle. spindle out they look the same.
i pulled a dana 50 ttb out of a 1994 f250 it has the big dana 60 looking size locking hub.

i want to see if they swap over

thanks
jason

 

[Double-S-Diesel]

I think they will work, I do believe the spindle its self is different, but the bearings are the same from one to the other. and I know the lock out hubs interchange.

 

[subway]

i beleave they can, they are the same bearing like stated but from what i have read the d50 spindle is slightly shorter. you also have to look at the area that the spindle shoulder goes into the steering knuckle. it is not long enough if the d60 caliper bracket is not cast into the knuckle. from what i have read they are not the same but can be used.

i beleave that every thing outside of that is the same though. i havent done this myself, just passing on what i have read.

 

[adrianspeeder]

I wanna say I remember reading no, but I've never played with a Dana 50.

The Dana 60 SAS section of fullsizebronco.com would be your best bet for searching an answer.

Adrianspeeder

 

[Nazty 4x4]

thanks, and no the caliper bracket is not cast onto the knuckle

 

[subway]

thanks, and no the caliper bracket is not cast onto the knuckle

that will be the deal breaker there for the spindles.....

 

[82F100SWB]

You can't use the spindle, but, the hub, bearings, lockout, and brake rotor are the same parts.