Search results

  1. R

    Pitman arm nut

    Hello can someone tell me what size socket I need to buy to fit the pitman arm nut?
  2. R

    Sulpher content

    Stopped for diesel fuel today and noticed that off road diesel and clear kerosene were both rated as not more than 500ppm. Does this mean the kerosene would be a better fuel than ULSD?
  3. R

    In Bed Fuel Tank

    Hello everyone. Can someone tell me if there are any problems with using an in bed fuel tank. I have a 84 F250 with a facet electric fuel pump. My main concern is will there be any problem with the fuel return being that it will be higher up.
  4. R

    Running Rough No Power

    Been having problems finding the problem with my 84 F250. Runs rough no power and surges. Checked fuel pressure at schrader valve it reads 3.5 pounds at idle, When I increase RPM it slowly drops to a point were the gauge starts showing a vacuum reading. I tried pulling fuel threw a gallon...
  5. R

    Fuel pressure and volume

    Having a problem with power loss.84 F250 Changed fuel filter still power loss. Hooked up a combination pressure and vac. gauge to schrader valve. Results were 3lb. cranking 3.5lb. at idle. Increase rpm and would drop to the point it would pull about 5lbs. of vaccume at 2000 RPM. Volume test was...
  6. R

    Lift

    I have an 84 F250 with stock springs. Truck has 35x12.50x16.5 BFG mud tires on it. No clearance problems. Just picked up some 37x12.50x16.5 tires cheap. What will I have to do to fit these tires. Truck is only used on road.
  7. R

    No fuel at schrader valve

    I have a 84 F250 truck has a loss of power. I changed the fuel filter about 50 miles ago noticed engine has no fuel at schrader valve when I check it while engine is at an idle. Can the filter be blocked up enough to cause this?
  8. R

    Glow plug check

    Can someone tell me when you check the glow plugs with a test light are you supposed to touch the terminal with the tester or the base of the glow plug.
  9. R

    coolant heater

    Hello everyone I have an 84 F250. I am looking at buying an after market block heater that goes into the heater hose. The auto store has a 1000 watt and a 1500 watt can someone tell me what temp these heaters will heat the coolant to.
  10. R

    Axle Ratio

    Hello everyone I have an 84 F250. The code on the door says axle code 73 can someone tell me what gear ratio that is?
  11. R

    Power steering noise

    Hello everyone I have a 84 F250. I had to have it towed two weeks ago due to a bad fuel pump. Had my friend tow it with my bronco about 2 miles with a tow strap while I was manualy steering the F250. Ever since I got the truck back on the road it whines from the steering pump at low speeds while...
  12. R

    fuel pump pressure

    Hello everyone I have a 84 F250 Truck shut off on me the other day while driving acts as if starving for fuel changed fuel filter ran about a mile shut off again notice there was no pressure at fuel filter bleeder. Changed the fuel pump ran about 15 min and shut off again. When I check for...
  13. R

    Oil Filters

    Hello I have an 84 F250 Can someone tell me what is the largest oil filter that fits the 6.9. I noticed the power stroke oil filters are quite large. Will they fit the 6.9. Thank You! Rock
  14. R

    Starter Solenoid

    Hello can someone tell me how the starter solenoid is triggered ? It seems to be from a ground wire that runs from the solenoid that is mounted on the fender apron? Thanks! Rock
  15. R

    Starter Solenoid

    Hello everyone. Every once in a while when I go to start the truck I get a click fom the starter solenoid followed by a two second delay before the starter starts turning the engine over. Tried cleaning the terminals on the solenoid but still having the same problem. I am thinking faulty...
  16. R

    E4OD Problem

    Hello everyone, I went to look at a 93 F250 IDI today. Solid truck but in order to get the trans to start off in first gear I would have to move the shift lever into first on the gear indicator. If I started out in drive the truck would start out in second gear. The trans did not slip at all...
  17. R

    Glow Plug Solenoid

    Hello everyone. Can someone tell me where the glow plug solenoid is located?
  18. R

    Brake Pedal Return

    Hello everyone. I recently bought a 89 F350. After stepping on the brake pedal, the pedal returns very slowly to the normal position?

Latest posts

Forum statistics

Threads
91,339
Posts
1,130,639
Members
24,141
Latest member
Cv axle

Members online

Total: 630 (members: 12, guests: 618)

Share this page

Top