Search results

  1. boxathey

    Truck Randomly Dies After 20 Min Of Running Wont Re Start For 30 Minutes

    Hello Im working on my uncles 2002 F-250 7.3 zf-6 4x4 , his truck starts right up runs great for about tenty thirty minutes. then it will die. truck will turn over really fast but wont start. about an hour later it will start right up and run perfect starting the cycle all over again. I...
  2. boxathey

    Installing New Return Line Kit On Factory Turbo

    Hello, I purchased a fuel line return kit about a year ago off a member here. Well of coarse i decide to install it now in the beginning of winter at below freezing weather. Anyways the T caps that are currently on my return lines are no longer available. Can i just purchase a brass T...
  3. boxathey

    7.3 powerstroke randomly stalls

    I'm working on my uncles 2002 ford f250 xlt 4x4 with the zf6. The truck will randomly shut off after about fifteen to thirty minutes of driving. I checked all the electrical connections I could think of. I found a fusible link near the passenger battery damn near totally coroded. I replaced...
  4. boxathey

    Need To Replace Oil Cooler

    Hello, quick question. Im getting ready to change my oil cooler in my 2004 6.0l im seeing right around 30 degree delta. I already have a sinister egr delete kit installed. do i have to take the intake manifold off to get the oil cooler off.
  5. boxathey

    Front Core Support 93 F250

    Hey guys, i was wondering if anyone had a good picture of a front core support. mine is in dyer need of repair. Both front cab mount bushings are 100 percent gone. plus where it attaches to the front fenders is also gone. I would like to repair it by welding new plates on it. but i do not...
  6. boxathey

    ZF-5 Questions

    Does anyone know what the recommended oil change interval is on the ZF-5 transmission. What oil type/grade should I use ? I would like to use a synthetic. Thanks
  7. boxathey

    RPM s Still Reading Low

    Hello, I was wondering if there are any of you that can verify your rpms on your guage. I have a zf5 5 speed with 3.55 gears. can you tell me roughly what rpm your reading in 3rd gear going 35mph. 4th gear going 50 mph , I just purchased a new tach sensor and it still seems low...
  8. boxathey

    IP Pump Questions

    I just installed a freshly rebuilt IP pump I purchased at a local diesel shop. (http://www.wimerfuelinjection.com/). It has a factory turbo, the IP pump was calibrated for a factory turbo also. after start up I let it warm up. Then using the timing meter I rented off of icanfixall i timed it...
  9. boxathey

    Fuel Injector Torque

    Hello, Im going to be pulling my injectors out to have them pop tested. Can you guys tell me what the re-torque spec is on these. I think its 20-25 ft-lbs but I might be way off. Thanks
  10. boxathey

    Fuel heater 93 7.3 idi

    Do you guys know of a way to test the fuel heater in the filter housing. I can hook up an amp probe and see what the current draw is. But I'm not sure what the draw is supposed to be . Any thoughts would be greatly appreciated.
  11. boxathey

    Rough Idle with puffs of white smoke

    Hello, I have a 93 f350 7.3 w factory turbo, my truck recently started blowing white smoke and what sounds to be missing a little when engine is cold to slightly warm. The truck starts just fine weather it be 0F or 50F. Once when it starts it coughs for over a minute and puffs white smoke...
  12. boxathey

    Oil Pressure Question

    Hello, i have a 1993 f350 7.3 idi with a factory turbo, I installed new qauges and my oil pressure seems low. I tied in at the top of my turbo with a T right with the factory oil pressure sensor. at idle my truck is at 19-20 psi. running down the road it only jumps up to 22-24 psi. it seems...
  13. boxathey

    Fuel System Question

    Hello, Im new to the forum but have been reading in the background for months now. I have a 93.5 f350 7.3 IDI 5-speed with the factory turbo 173k. I love the truck. I have read over a few threads people installing electric fuel pumps on there rigs. i have a couple questions 1. is the lift...

Latest posts

Forum statistics

Threads
91,284
Posts
1,129,785
Members
24,099
Latest member
IDIBronco86

Members online

Total: 686 (members: 3, guests: 683)

Share this page

Top