I appreciate all the replies everyone. Thank you all....I see now i should be more concerned about extra lubrication in the pump and injector areas as opposed to the upper cylinder...to bad we couldnt figure out how to add the afformentioned product into the fuel system so it would directly...
I was wondering since i am a little bit concerned about upper cylinder lubrication ( because we no longer get it from the sulphur that was in diesel fuel due to goverment regulation ) anyway back to the topic I was wondering if any of you have used or would use a product such as this one...
I fully understand the frustration level Scott...believe me i have been there done that myself on more than one occasion....I guess my frustration level is just at this point also frustrated....my point was and after re reading my post completely missed....It just seems that whenever something...
You know what dyoung you come in here constantly bitching that your truck is a piece of crap but you are also the one that has it posted that you like to see the tach go past 4 grand +....I have been driving the truck in my sig for 9 years i have changed the oil every 5000 miles, replace the...
Hey! Thank you for asking this question been wondering the same exact thing for the last couple days just have not posted it yet. I await an answer eagerly since it dont make sense to me.
The recovery bed and the extra 100 foot coil of cable is by far worth the trade alone. you can buy a 12 volt pump to replace the existing pto to drive the hydraulics and run the winches and any other hydraulic equipment.
Recovery beds that are in good usable condition here go from $800 to...
As for the actual content of my thread the reason i am so bitchy about this is because i have done business with said company for about 17 years off and on and this was not the 1st time i have had trouble with them. I understand that people will often call to order then never pick up the part...
No offense taken....that avatar was just me trying to start a little bit fun with towcat. Since it did not take off as well as i expected it to i decided to put one of my truck back up.
So i need a master cylinder rebuild kit for my truck...the wife gets on the phone calls around to several autoparts stores in our area and comes up with one for $ 33.00 at the Checker in Grand Junction colo.:D
Hey great they are the lowest price but the have to order it will be in in 24...
Well my .02 is that i get 12 mpg in the truck in my sig whether i have 2650 pounds of coal in the bed or whether i am pulling the 36 foot 5er or whether i am empty...it has done this since the day i bought her she loves to cruise at 63 mph that seems to be her sweet spot....she has 167000 mph...
Ok I have been reading this thread all day long and i will not sit quietly by like i usually do on the vast majority of the threads posted only because i can relate to both parties involved in this and it is my belief that a little education can ( with luck ) help in a civil and respectful...
Well in one of my finer brain dead moments i managed to drill a 1/4 inch drill bit 3 inches into my left thigh while trying to make a heat shield for my exhaust system on a ford bronco.
Has anyone thought about a thermostat being sticky? even brand new ones sometimes fail....i had this exact same prob on a gasser and it took me 3 weeks before someone recomended a T stat check. BINGO checked the stat by putting in boiling water did not open fully replaced said stat over...
Just as a thought why has no one looked into having a full copper head gasket made to try out on these IDI's ? I mean they are used for high horsepower and high compression gassers so why would they not work for a diesel? If this is one of the weak spots in our IDI's then would that not...
Ford posts $2.1 billion 1Q profit on strong sales.
Ford, the only Detroit-area automaker to shun government aid and stay out of bankruptcy protection last year, gained market share from crosstown rivals General Motors Co. and Chrysler Group LLC. It also benefited from Toyota Motor Corp.'s...
The inspection plate does keep dirt and crud from getting up and causing premature failure of your rear main seal on your engine and your front seals on your tranny if you have an automatic. I use to believe that it didnt do anything until my front tire kicked a rock up going down the hwy...
A waterbed heater will not produce enough heat to melt plastic unless it is malfunctioning.
Just food for thought they make tank heaters for the holding tanks on various RV's these are design to keep them from freezing in extemely cold temps.
My apologies i often forget that aspect of it since i fill up my tanks at a truck stop that has new diesel brought in several times a week due to the large volume.
My understanding is that if you are using the diesel in your tanks frequently then algae growth and water in the tanks is not an issue. but if you store diesel in above ground tanks such as the ones we commonly use on farms for the tractors and they set for extended periods of time without...
When i had my daughter in public school i would set down and go over all of her tests and homework after the teacher graded her....there were many times that both myself and my wife found 100% on tests that had several mistakes in them. Pointed this out to the teacher as well as the principal...
I run the Napa Gold filters on my truck never had any kind of problem with them although i change them out twice a year sometimes 3 times a year depending on how hard i run the truck and how often we have dust storms in this area.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.