Search results

  1. Ole BlackBetty

    Part I’d help

    Ok, when I open ed my drivers door to do some work on my new gauges, this item was in the drivers floor board . It must have come from under the seat or under the dash. It is about 8 inches long and 3x3 approximately, it is made of hard foam. Who knows what this is and where it goes?
  2. Ole BlackBetty

    Fuel tank showerheads

    What are these two screens for that came with my new shower head? About a half inch round and 2 inches long
  3. Ole BlackBetty

    Maxtow gauges

    My truck has a stock 7.3 turbo. What is the max psi put out by the turbo? They offer 3 different ranges of gauges . Also which EGT gauge should I buy? There is one for 1500 degree max and one for I think 3000 degree.
  4. Ole BlackBetty

    E4OD speed sensor?

    ok, I looked at all the electric connections on my transmission, 4x4 I could find anything that looked like a speed sensor on the tranny. I do have an ABS speed sensor on rear diff.
  5. Ole BlackBetty

    E4od questions/trouble

    First off, I have always had trouble with my Transmission going into limp mode OD light flashing. If i keep OD turned off until i get to hiway speed, approximately 50mph and then turn on OD truck does fine. I turn it back off when i get below 50mph and drive around town with no trouble. just...
  6. Ole BlackBetty

    bouncing speedometer

    ok I read a few threads, but did not give me answers. At 60mph and above my speedometer needle bounces violently. I do have a flashing od light. trans pulls and drives good tach is steady. I clear the od light everyonce in awhile and after driving up to temp. it will come back on. Trans temp...
  7. Ole BlackBetty

    E4od torque converter

    is there any way to tell if the torque converter is bad, or not locking up?
  8. Ole BlackBetty

    Ball joints

    So I took ol black Betty in today and got some new shoes on her. I had Hibdons do a front end alignment check to see if anything was needed. They said upper and lower ball joints are a little worn , not to bad be need to changed to stop unwanted wear on new tires. The quoted about $900.00 to do...
  9. Ole BlackBetty

    1994 starter

    ok, I have bought 2 starters off amazon, that will not throw the bendics. part Number 17578R is this correct part number for a 1994 7.3T engine? I need help
  10. Ole BlackBetty

    E4od transmission parts

    Hello again, I tried a search and couldnt find anything. I am needing to know a list of what is best parts for a bullet proof E4OD rebuild. I think it was Trackspeeder , that listed several items once before. Any help would be good to know, TIA
  11. Ole BlackBetty

    dually wheel

    anyone know where i can get a steel dually rim for a 1994 F350? need one for a spare
  12. Ole BlackBetty

    Harbor fright compression gauge

    Ok, so the proper fitting will not go in glowplug hole, I have read where some had to cut it off for it to fit. If I cut mine off it will eliminate the shader valve in the end of it. Will it still read pressure?
  13. Ole BlackBetty

    Running rough, hard start

    The last rip my truck, 1994 7.3T made was June of 2020, drovec195 miles each way to lake for a week of camping, healing a 12 foot overhead camper with no trouble on trip. I have started truck in drive a few times in the past 2 years, other than an occasional dead battery she always started. In...
  14. Ole BlackBetty

    Ip

    How much to have an injector pump rebuilt?
  15. Ole BlackBetty

    Tach

    Ok, last week I was driving to work and tach stopped working. When I got to town, and stopped at stop sign, tried to take off when light turned green, truck didn't want to move. It was straining so I pulled shifter down to second and it came to life. E4od auto. Truck is not down shifting and...
  16. Ole BlackBetty

    E4od controller

    What is the best bang for the money, stand alone controller? Sent from my SAMSUNG-SM-N910A using Tapatalk
  17. Ole BlackBetty

    Unknown pin

    parked and went in store, when I came out to leave, truck would not go out of park, into gear. While wiggling column shifter back and forth, this small pin fell out from under dash. And it shifted into reverse and drive. Anyone know where this pin goes? Sent from my SAMSUNG-SM-N910A using Tapatalk
  18. Ole BlackBetty

    Oklahoma

    Who on here, lives in Oklahoma, particularly central oklahoma. I live east of norman, oklahoma, by lake Thunderbird. Just wondering if I have any fellow oilburners.net I could maybe meet up with sometime. Sent from my SAMSUNG-SM-N910A using Tapatalk
  19. Ole BlackBetty

    Serpentine belt tensioner

    Well my tensioner came apart this morning on the way to work, bent a few of the fan blades and ripped out my transmission cooling lines. This is the second tensioner I've put on in about 2 years! Is there a better one out there, than what the parts store offer. Truck has 174000 miles Sent from...
  20. Ole BlackBetty

    Transmission rebuild

    I am considering having a local transmission shop overhaul my e4od. I am asking for opinions on what better than stock parts do I need to request he use to make a dependable transmission? Sent from my SAMSUNG-SM-N910A using Tapatalk
  21. Ole BlackBetty

    Trans cooler

    Looking for opinions on good overcounter tranny cooler for e4od Sent from my SAMSUNG-SM-N910A using Tapatalk
  22. Ole BlackBetty

    Vacuum pump question

    What does the vacuum pump supply vacuum too, other than the brake booster ?
  23. Ole BlackBetty

    Hard pedal

    Make brake pedal suddenly became very hard to push and brake light comes on. I think it might be the brake booster, anyone else have any opinions? Vacuum pump seems to be working, i pulled the vacuum line from the booster and it forms a suction on my thumb.
  24. Ole BlackBetty

    E4OD trouble codes

    Ok i am getting a code 62 and 67 from my code reader. The book that came with my code reader lists about 3 or 4 different things for these codes, dependant on what motor and vehicle type , car or truck. None of the motor options listed are IDI . So what do your code lists show as tje problem?
  25. Ole BlackBetty

    Neutral safety switch

    Tried adjustimg my safety switch today and thos is as close as it will get to line up.

Latest posts

Forum statistics

Threads
92,996
Posts
1,155,950
Members
26,579
Latest member
truckonfire

Members online

Total: 1,600 (members: 7, guests: 1,593)

Share this page

Top