You can use a power door lock actuator, or a solenoid for a shaved handle system, to engage the throttle under the hood while the starter is cranking. As soon as it starts it releases the solenoid and since the throttle has moved forward the cold start high idle has clicked forward. It runs on...
Here's a few more pics. These engine were not run in tandem. One is the original, the other was shipped up here as the replacement. I also have a full manual with all specs and all repair operations for the various systems. Came with full wiring cables from engine to complete instrumentation...
I have two of these marine 7.3 idi's. One is sitting here 100% complete. Have a full shop manual with all specs and systems, and full control panel/gauges and wiring.
Hello all. I have an air to water intercooler off of a marine 7.3. Mounts directly to the intake. Obviously some adaptation required. Also have the belt driven water pump and brackets to circulate the water. Add a small radiator in front and you're set. 500$ plus shipping.
Also have the 275hp...
Longer is better. If you want to go all out, install a steering box brace as well. I've used the clamps from a jeep kit and made my own bar that runs over to the pass side frame. Made a noticeable difference.
Yes you need one. Steering forces from the steering box try and push the axle away from or pull it towards the box. This movement tries to twist the leaf springs and bushings. The track bar keeps the axle centered and resists this movement. It also helps control bumpsteer. It needs to be on the...
Judge, jury and executioner. Nice. Now trying to justify it. This place would be a much better place if people erred on the side of helpfulness. I know, an argument I'll never win with you and others like you. All good, hopefully the original poster can go from that link to others. I won't bow...
Nice. The words wasted here could have been used to help the guy out. Age old web forum mentality. Human nature I guess.
This might get you started. I too know the frustration of trying to make search engines work...
I tested quite a bit with a vacuum/pressure guage on my down tube. Same set up with a pulse air check valve that has a lighter opening rate. There wasn't enough vac. generated in the down pipe to open the checkvalve. Removing the check valve allowed pressure in the downpipe to escape. Wasn't...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.