What a Bad U-Joint Looks Like

[NeverHave-I-Ether]

xc_hide_links_from_guests_guests_error_hide_media

This is my next project, ordered some Mooj U-joints off Rockauto.

Never-Have-I-Ether

 

[Jesus Freak]

The front drive shaft on the 86 bronco I just bought is like that on both ends.

 

[NeverHave-I-Ether]

The front drive shaft on the 86 bronco I just bought is like that on both ends.

Sounds like we both got work to do! Lol

I went ahead and ordered all 6 for my drive shafts and front axle. Going to procrastinate and wait to do my entire front end.

Never-Have-I-Ether

 

[Jesus Freak]

I'm in no hurry, it's just the front. The rear shaft is tight.

 

[chillman88]

You should see the one I pulled my Dana 60 from. I don't think it had any needle bearings in it for a couple years.

Actually.... Found the video lol

xc_hide_links_from_guests_guests_error_hide_media

 

[IDIBRONCO]

You should see the one I pulled my Dana 60 from. I don't think it had any needle bearings in it for a couple years.

I had one that looked about like that on the 78 F100 that I used to have.

 

[Nero]

Nah just pump it full o grease and keep going, French fry grease works the best

 

[Jesus Freak]

French fry grease works the best

That's the spirit Nero! Thinking outside of the box, but on the can! Ketchup in the tank, french fries in the bearings...