Turbo guys? Did i bend my firewall engough?

[Alex S]

just getting ready for the turbo install next weekend (if the weather is good) and was wondering if i deformed the firewall enough to fit the ATS setup

Thanks

 

[dyoung14]

you bent it much more than i had too mine fit just fine

 

[NMB2]

looks good to me. all you really need to do is pound the seam flat from the center all the way over to the pass side of the tunnel.

 

[Alex S]

cool then i should have room to play with maybe look at a 4" down pipe

 

[dyoung14]

cool then i should have room to play with maybe look at a 4" down pipe

yea it should be no problem for you to slide the up pipe in there, i didnt really bend mine enough but i didnt have much to bend it with so i kinda had to force mine in but its all good you could probly fit a 4 inch downpipe with all that room

 

[Bill-W]

I have the same shut of valve on my cheater bar! I though you stole mine when I first saw it!

 

[subway]

looks like it should clear ro me, i only had to do minimal bending but i go tthe crushed downpipe.

its a good excuse for a body lift to.....

 

[dyoung14]

looks like it should clear ro me, i only had to do minimal bending but i go tthe crushed downpipe.

its a good excuse for a body lift to.....

I also used the crushed downpipe, i got no problems boosting around 15 psi

 

[6.9poweredscout]

i'm sorry i don't see a firewall.... i'm to busy staring at the scout......

-Jon

 

[Alex S]

I have the same shut of valve on my cheater bar! I though you stole mine when I first saw it!

hahah nice

actually its 1" 316 Stainless steel but its full of lead so its heaver then the 2" sched 40

 

[Alex S]

i'm sorry i don't see a firewall.... i'm to busy staring at the scout......

-Jon

hahah eagle eye hu should of had the camera more to the right

 

[6.9poweredscout]

hahah eagle eye hu should of had the camera more to the right

yes you could of taken it at a better angle...

-Jon