Throw out loose on shaft

[85rollback]

Installing the LUK clutch assy for the swap of a ZF5 where a four speed was. 1986 6.9. The new throw put bearing (INA brand) is a verrrry loose fit on the shaft it slides on. I'm talking .025 difference in diameters. Is this OK? Will it just center itself when I push in the clutch?

 

[Nero]

I believe its centered by the release fork. That amount of play doesnt seem unusual to me.

 

[85rollback]

I believe its centered by the release fork. That amount of play doesnt seem unusual to me.

That's what I'm thinking, but it's seems just a little too loose.

 

[85rollback]

I found the correct part FB-01747-CA or FB01747CA. Slightly smaller in diameter than the one in the LUK 07-225 clutch/flywheel kit.