Thanks for the compliments, I'm awful proud of it. I have some things I'd like to do it to make it more enjoyable to me. Bucket seats (any comments on year models that will interchange easily). Would also like to have a 5spd in it, but that can wait. First thing I need to do is get some reliable guages in it as the Oil pressure guage doesn't seem too accurate (pressure seems to go down when engine RPM's are increased and never reads past the O in Normal. I'm hoping this a guage problem and not something more (the truck runs perfect, no knock or anything that would suggest low oil pressure), the temp guage is all over the place but never above midway (drove 60 miles at highway speeds and temp guage was almost not reading needle on cold side. Also need to put a tach on it as there wasn't one from the factory, but after reading some posts it looks like the middle spot in cluster will come out and a factory tach from a donor truck would go in easily. I look forward to gaining more knowledge from this site and appreciate any and all comments. One other thing I've been looking for is rear end gears that are in it, door sticker code is C9 for axle and P for transmission. I'm thinking 3.55's and a T-19 tranny, I haven't crawled under and looked at the axle itself for markings yet. I do have some very nice Diamond Plate running boards and all hardware that came off of it if anyone is interested, I'll be posting pics of them in the marketplace soon.