DT360 into 1991 F350

[6.9poweredscout]

I think it'll be much better. As hard as I can beat it/lug it/abuse it, haven't seen over 1000 egt.

Sent from my SM-G920V using Tapatalk

 

[Blumkin]

Sorry to bug ya with questions... how did you end up driving the tach?

 

[6.9poweredscout]

Not a problem, that's what forums are for! I had a tone wheel made, I'm going to use a rear diff sensor to read it. I need to make a bracket still to hold the sensor. I had it fluctuate at idle, but never dialed it in.

Sent from my SM-G920V using Tapatalk

 

[mack]

such an awsome build thank you for sharing

 

[6.9poweredscout]

Thanks for checking it out.

Sent from my SM-G920V using Tapatalk

 

[6.9poweredscout]

The borg Warner turbo is awesome. Tows like a freight train and maxes out my 35 psi gauge. I'll update with some engine pictures and more junk towed...

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

6-71 powered gmc

You must be registered for see images attach

Upgraded to a manual column and 79 sport wheel.

You must be registered for see images attach

 

[comotionman]

How about an update?

 

[MasterBruh]

Just wanted to say I love this build. My IDI is a little tired now, but I have been looking at this thread for years. Always something in the way, university or work always took my time but I think I will finally do it. I plan on doing what you did with the engine but backed by an Eaton Fuller FSO6406 or 8406, a bit more work involved but it will hold up well behind the engine. I may rebuild and stud the engine depending on its condition, but I don't want crazy power out of it either so upgrading the A pump, Injectors and turbo may be all I will do to it.

My biggest concerns are getting the engine to fit with the V belts set up (or convert the engine and accessories to serpentine) and making good engine mounts for this beast. My truck is super duper axle swapped so there is a bit more restriction in the frame, I hope I dont have to complete delete the engine cradle cross member. I'll see what happens as problems arise.

Either way, the search for a 360 finally begins for me. Thank you very much for this write up you did a decade ago, I would have never even thought of this swap if I'd never come across this

 

[u2slow]

I plan on doing what you did with the engine but backed by an Eaton Fuller FSO6406 or 8406, a bit more work involved but it will hold up well behind the engine.

FWIW, I was shopping for these recently. 5305/5306 is commonly used with the 5.9 cummins, and the 6306 shows up with DT466 and 7.2 Cats.

I ended up with a 6306 due to price and availability.

The Spicer 7 speeds (aka "6plus") are another one to look at.