freebird01
Post Turtle!
'85 block on the stand
almost $600 in machine work done to it.
bored .030 over
new cam bearings installed
cleaned and painted ford blue
'85 heads
valve seats and valves re-ground
also cleaned and painted.
valve guides inspected
comes with a set of forged flat top pistons on rods. was out of a 30k mile engine. one piston replaced and balanced to the rest by same shop.
all machine work done by simpson machine in clarkstown,pa (receipt included)
comes with a set of std rod and main bearings
new .030 moly rings
2 sets of used roller lifters
(block is roller ready)
tins and timing cover from a mercury grand marquis wagon
new uninstalled freeze plugs
located near 17067
$600 firm come pick up. will consider trade for a D60 front for my 88 F250
almost $600 in machine work done to it.
bored .030 over
new cam bearings installed
cleaned and painted ford blue
'85 heads
valve seats and valves re-ground
also cleaned and painted.
valve guides inspected
comes with a set of forged flat top pistons on rods. was out of a 30k mile engine. one piston replaced and balanced to the rest by same shop.
all machine work done by simpson machine in clarkstown,pa (receipt included)
comes with a set of std rod and main bearings
new .030 moly rings
2 sets of used roller lifters
(block is roller ready)
tins and timing cover from a mercury grand marquis wagon
new uninstalled freeze plugs
located near 17067
$600 firm come pick up. will consider trade for a D60 front for my 88 F250
