Search results

  1. 93_444idi

    96 cummins swap

    17k new posts since the last time I logged in lol anyways, figured I'd update. I sold my idi because of a deal on a superduty I couldn't pass up. $500 for a crewcab longbed 4wd 99 powerstroke. I was already planning on swapping a cummins in my 93, so I'm putting it in this superduty...
  2. 93_444idi

    factory turbo / engine / luk smf and clutch

    Not sure of mileage on engine, it's a remand jasper engine. It has a hypermax cowl intake and a banks 3" downpipe that will go with it, along with a luk single mass flywheel and clutch, an extra fuel pump, lift pump, glowplug relay, oil pan (the one on it has a bung for an oil temp gauge I...
  3. 93_444idi

    Trying to identify turbo

    I need to buy a compressor wheel for this turbo and can't figure out what it is. I believe it's some sort of industrial turbo, it's a Garrett and was sold by AlliedSignal (a company that no longer exists). It has a 4" inlet and 4" outlet. I used a mic and the compressor wheel inducer is 60mm...
  4. 93_444idi

    Help please. fuel pump bad? or injector?

    I just started noticing this issue today, but I haven't been able to diagnose what exactly is causing it yet. My motor is a jasper reman with unknown mileage, I do believe it is reaching that 150k mark where the fuel system needs replaced. Symptoms: There is a new rattle under the hood at...
  5. 93_444idi

    anything worth pulling off an 04 dt466?

    not sure where to ask this question so I figured I'd ask here. A junkyard here has a rig with a 466 in it. It's not mech pump and it has a vgt and a diamond logic ecm. anyone know of anything worth pulling? I know I can get anything off it for dirt cheap. I'm guessing it's fuel injection...
  6. 93_444idi

    PSD Injector Driver

    F7TF-12B599-AA $200 shipped
  7. 93_444idi

    International Diamond Logic ECM

    Part # 1833558C1 Out of a running t444e $550 shipped Connectors look nasty in the picture, but as the sticker says, connectors have dielectric grease on them.
  8. 93_444idi

    Go taller?

    I've got a hot deal on a 3" shackle reverse kit but I'm not sure if I want it.. It's not an issue of if I can do it, but if I can afford tires that'll look good under 10" of lift on a daily driver. And whether it's really necessary. I'm running 37s now and I like a lot of wheel well clearance...
  9. 93_444idi

    whats a reasonable price?

    what would be a reasonable price to ask for my complete engine and smf with clutch? It's complete engine, turbo assy with cowl intake and 3" downpipe, luk smf/clutch, and a spare 93 7.3 i have sitting here that has a new water pump and lift pump. I was thinking $1400, is that too much? I've...
  10. 93_444idi

    serpentine belt squeeking

    I've gone through 2 gates serpentine belts in the past year now. Nothing appears to be wrong with them but all the sudden they start squeaking. A week ago it was working great, no squeek except when I turn it off. Yesterday it started to do so at idle and then got worse as I increased rpms...
  11. 93_444idi

    typ4 cam

    asking $130 + shipping, never used. whoever it was i was talking to about it before (had to erase old pms) let me know if you're still interested and you'll get first dibs.
  12. 93_444idi

    12v cummins swap experiences

    those of you that have done 12v swaps to replace their idis, what kind of snags did you run in to doing so? What extra expenses came up you didn't forsee? did you use destroked.com or fordcummins.com for adaptors/parts? I'm on the fence about doing the swap, if everything went right it...
  13. 93_444idi

    turbo whistle and a little smoke vid

    took it a while back, figured id post. camera doesnt do justice for the turbo whistle but that's always the case. i didnt bother editing so you get to listen to me climb in and out of the truck. i have to say i'm jealous of the turbo on my brothers idi though. those ball-bearing turbos have...
  14. 93_444idi

    more power = better fuel economy?

    I'm looking at about 13mpg unloaded right now, and that's cruising down the highway not putting my foot into it. I've got lots of plans regarding adding more air and fuel but if 13mpg is about the best I can expect I may just sell it and look for a more "eco-friendly" diesel to play with. I...
  15. 93_444idi

    Almost made a 900 mile trip without an issue

    Well I drove out to Virginia from Missouri to visit some family and decided to test my truck. I was pretty impressed. AC blew cold the whole time, engine oil temp never went over 200* and water temp never went over N on normal on the dummy guage. I went with my bro and his friend and since...
  16. 93_444idi

    Taylor's St. Louis Junkyard

    Anyone needing cheap parts for an N/A idi that lives nearby should check this junkyard out.. Went there today and they have 8 U-haul trucks with idis in them. All 2wd dually F350 4.10 open. Got nice radiators and well maintained 7.3s. I believe they're all e4od but I'm not sure. Some had...
  17. 93_444idi

    Fixed moisture in headlight issue

    I had one headlight that for some reason was collecting water. Well headlights are a pita to get out on these trucks so I just ran it and figured I'll fix it when something breaks. One night the water hit the bulb and it was toast. Well to drain it I drilled a small hole in the bottom of the...
  18. 93_444idi

    What do you think? Feelin stacks?

    Debating getting some 5" or 6" aussie stacks. I want something to make it stand out a little more. The truck wont be black much longer though. After my engine project I'm going to put my white rust free body on this truck. Going to do centurian stripping on the sides in blue and I just...
  19. 93_444idi

    Build thread

    The recent accident set things back but when I get back from vacation 2nd week of august I plan on starting. Plan on having it finished by the end of the year. I've got a spare running 7.3 sitting in the shop I'll be building and then swapping in. I'm not gonna mess with the bottom end...
  20. 93_444idi

    WTB 16.5x10 wheels

    either a full set of welds or eagles or a single eagle just to replace one I broke. If anyone has anything this size please let me know, I'm willing to travel a good ways to get them. Not interested in black wheels. Thanks
  21. 93_444idi

    very loud gear noise with zf5

    I know some noise is to be expected when lugging in 1st, 2nd, or reverse. But mine is very loud. It does have a luk smf conversion. My uncle has 2 smf zf5 460s and neither of them make this loud gear noise. Is this a diesel only occurance? I'm running 4 qts of mercon V, thats what a...
  22. 93_444idi

    4"/6" lift ifs drop brackets

    what the title says. they're rough country brackets. asking 100. straight-axled my truck so i dont need em. also selling my d50 ifs with 4.10s and recently replaced ball joints, axle joints, and pivot bushings. all replaced within the past year. has a new drag link too, replaced it a...
  23. 93_444idi

    14 bolt rear swap questions

    I've got a good deal on a disk brake 14 bolt rear with a detroit locker in it that i'd really like to put under my truck. it's all set up to go under a ford, the only issue i see is no plug for a spedometer.. is there any way i can run my spedometer to another spot? transfer case maybe? or...
  24. 93_444idi

    where do i buy a new luk clutch?

    the front seal on my tranny was junk and puked fluid all over my clutch. I have a luk smf system and I'm wondering where I get another 12" clutch disk for a smf? Does it have to be a luk clutch? napa and oreilleys only show dmf clutches (which makes sense i realize since thats all they had...
  25. 93_444idi

    want to remove wastegate on 093

    I have mine plugged as it is, I'd like to just remove it and make it a non-wastegated turbo. Hoping I can upgrade at the same time. Is there a bigger exhaust housing I can buy that is the same design minus the wastegate?

Latest posts

Forum statistics

Threads
91,299
Posts
1,129,925
Members
24,108
Latest member
Lance

Members online

Total: 435 (members: 5, guests: 430)

Share this page

Top