Recent content by seriousbum

  1. S

    WMO/*** filter lifespan?

    Ditto here. Let it settle. Don't take it off the bottom. Heat makes the filter last longer. I use a gravity fed system too. Sometimes you can take the filter and clean it a little if you use gravity. Go on Ebay and find some bag type filters. I use multiple filters and the system lasts longer.
  2. S

    portable WMO

    I have put 70k miles on my 7.3 2002 using WMO and WVO. I would disagree with you slightly. You have to have a system designed to heat the oil. If there is an injection pump the oil needs to be at 160degrees before the pump. I have the other style with high pressure oil injection and I only have...
  3. S

    portable WMO

    Are you kidding? The filter on the go ideas are crazy. WMO can be filtered and used for fuel but it has to be cleaned of water, the most dangerous contaminant. In the case of WMO, antifreeze is also a huge problem. This means setting up some kind of system. I would recommend a trailer or some...
  4. S

    Centrifuge vs. Waterfilters,socks,bags,etc.?

    I have never tested my oil as was suggested above. However, I run my oil through a 1 micron bag filter as a final step. I also use a SpinnerII centrifuge. I run both a bag filter system and the centrifuge. What I have found is that it cuts down the centrifuge time by using a bag filter. The...
  5. S

    pumping wmo

    chevy oil pump Here is the link: http://cgi.ebay.com/ebaymotors/WASTE-VEGETABLE-OIL-WVO-SVO-SMALL-BLOCK-CHEV-GEAR-PUMP-_W0QQcmdZViewItemQQhashZitem255a284d00QQitemZ160426380544QQptZMotorsQ5fCarQ5fTruckQ5fPartsQ5fAccessories
  6. S

    Centrifuge vs. Waterfilters,socks,bags,etc.?

    I have a little different philosophy. I use both a centrifuge and bag filters. I buy bag filters and have them set up over my tank in sets of three. I start at 400 microns and filter down to 1 micron with bags. In order to get the oil through the smaller filters (below 100 microns) you have to...
  7. S

    pumping wmo

    oil pump What I have found handiest is to buy a remanf small block chevy oil pump from a guy on Ebay. It costs about $50 bucks plus shipping. I then use a 3/8s drill to power the pump. With my setup it takes about 8 min to empty a drum of motor oil. Take a look at the guy on Ebay's listing...
  8. S

    WMO/*** filter lifespan?

    Tank heater There is an easier way. Go to Ebay and put in wvo. You will find a tank heater that has a 110 element, a guard and thermostat. Then you just throw it in the oil and plug it in. Oil is non conductive. You can buy the same thing at most farm and ranch supply stores. Either place it...
  9. S

    micron rating?

    It states that this is a 10 micron filter. That isn't good enough for a Pstroke. The OEM fuel filter is 5 micron and you will be quicklly clogging it and changing a $30 filter.

Latest posts

Forum statistics

Threads
91,345
Posts
1,130,760
Members
24,143
Latest member
Cv axle
Top