Recent content by GusZiegler
-
G
Hardware Sizes and Torque Specs
Hey everyone, Doing some work on my 92 f250 and I had to cut my way through a decent amount of hardware since this truck has lived outside in Minnesota it's whole life. Anyways, I'm now in the market for new front and rear gas tank bolts, and bolts for the center support of the driveshaft. I...- GusZiegler
- Thread
- 7.3 7.3 idi driveshaft frame hardware idi leaf spring suspension torque
- Replies: 5
- Forum: 6.9L IH & 7.3L IDI Diesels
-
G
7.3 idi Hard Starting
Hello, My 7.3 idi sat for about a year while i was off for school. When I came back i replaced the injectors, injection pump, and upgraded to the transicold carrier electric fuel pump. I've driven it a couple times since and there has been some white smoke upon startup and it's getting...- GusZiegler
- Thread
- Replies: 3
- Forum: 6.9L IH & 7.3L IDI Diesels
-
G
Vinegar in coolant?
So this last week I was changing out my oil cooler and deicided to add a coolant filter while I was at it. In the process of flushing the system i cleaned it out with 4 gallons of distilled water and 4 gallons of vinegar. I tried to flush out as much of the water/vinegar mixture as I could, but...- GusZiegler
- Thread
- Replies: 0
- Forum: 6.9L IH & 7.3L IDI Diesels
-
G
7.3 IDI oil cooler
The tube bundle has a small pinhole that i assume is from rusting out. there are no dents or scrapes so rust is the best bet. Even with such a small hole (you wouldn't know it was there if the truck wasn't running) it pushes oil through like you wouldn't believe. As for your tube bundle, another...- GusZiegler
- Post #9
- Forum: 6.9L IH & 7.3L IDI Diesels
-
G
7.3 IDI oil cooler
I'm looking into zinc electroplating if i can find someone near me who does it for a reasonable price- GusZiegler
- Post #8
- Forum: 6.9L IH & 7.3L IDI Diesels
-
G
7.3 IDI oil cooler
It corroded through on the side and is leaking oil right after i replace the orings.- GusZiegler
- Post #5
- Forum: 6.9L IH & 7.3L IDI Diesels
-
G
7.3 IDI oil cooler
Looking for an oil cooler for my truck and i haven't had much luck. Non of the scrap yards around here have any and the only ones i can find on the internet are brand new and 400+ dollars. If you know where to get one or are selling one that would be very helpful. Also, any thoughts on zinc...- GusZiegler
- Thread
- Replies: 8
- Forum: 6.9L IH & 7.3L IDI Diesels
