VandalS
Full Access Member
I'm planning to do a body swap this weekend and want to check which wires I need to keep. If I've got it sorted, the only wire for the engine from the cab is the ignition to starter and ignition to GP controller. There are sensor wires for the oil P, water T, and tach. Is everything else pretty self contained or found in the chassis harness? I'd like to start pulling the body and have the donor cab (Jeep) ready to go.
On my engine, I've removed the manual fuel pump and the fuel heater/water separator (replaced with a full fuel/water separator unit) and also removed the A/C compressor.
On my engine, I've removed the manual fuel pump and the fuel heater/water separator (replaced with a full fuel/water separator unit) and also removed the A/C compressor.