Which type of controller is this? See picture
I ran a wire directly from the passenger battery to the IP pump electrical prong closest to the radiator. Side note, it ran connected to the prong closest to the driver, just with a long slow idle down in between gears when shifting the 5 speed manual sd42 tranny. I have no since read the comments and attached the battery supplied wire to the prong closest to the radiator. It runs fine now but wont shut off unless I pull the wire. Thanks for the heads up there.
Glow plug connective caps are melted so I assume the whole system fried. I will keep driving it as is until I can track one down. I have read on a forum that the 6.0 harness with new zd9 Glow plugs will work in the 6.9 system. The only splicing is bringing the 4 wires down into 1 in order to run back to the GPC. Is this true? If so it can save a lot if money. I assume my glow pmugs are fried. They are motorcraft I know that. Any trick to getting them out without cracking the tips off in the head?
You must be registered for see images attach