idi_Marty
Full Access Member
I was reading an article and it stated that injectors were retracted .060" from the combustion chamber on 7.3 heads. In regards to the 6.9 configuration, and that this was done for emission reasons.
My question is, that is it possible and would there be any benefits to milling the injectors hole .060"? Purely hypothetical, and just curious as to the effects that it could have in regards to the precombustion chamber, and fuel combustion. Thanks in advance for any info.
1994 Crew Cab F-350, 7.3L idi Turbo Diesel, 4x4, auto, DRW, Tollesboro, Ky
My question is, that is it possible and would there be any benefits to milling the injectors hole .060"? Purely hypothetical, and just curious as to the effects that it could have in regards to the precombustion chamber, and fuel combustion. Thanks in advance for any info.
1994 Crew Cab F-350, 7.3L idi Turbo Diesel, 4x4, auto, DRW, Tollesboro, Ky