I'm thinking about doing a long route (3500+ miles) over the next 6-8 months despite fuel prices, so I really need my Gear Vendors overdrive installed soon, if at all possible.
I'll need to have the C6 tail housing swapped out, the GVOD mounted, the driveline shortened/balanced, new U-joints, carrier bearing, etc. Not worried about the GVOD wiring, I can do that myself afterwards.
I need a shop/person experienced with them or can follow printed instructions and not mess up. I have the installation manual from GV.
I'd need it done in two days or less probably, since even "cheap" motels are expensive anymore (~$100/night), and the RV is my house, so I can't be without it for a week.
Can anyone recommend a good shop around these areas:
Along I-84/I-86 in Idaho (Boise, Twin Falls, Pocatello, etc)
Along I-15 between Pocatello ID & Ogden UT
Along I-84/I-80 between Ogden UT & Cheyenne WY
I know it's a long shot, but figured I'd ask.
I'll need to have the C6 tail housing swapped out, the GVOD mounted, the driveline shortened/balanced, new U-joints, carrier bearing, etc. Not worried about the GVOD wiring, I can do that myself afterwards.
I need a shop/person experienced with them or can follow printed instructions and not mess up. I have the installation manual from GV.
I'd need it done in two days or less probably, since even "cheap" motels are expensive anymore (~$100/night), and the RV is my house, so I can't be without it for a week.
Can anyone recommend a good shop around these areas:
Along I-84/I-86 in Idaho (Boise, Twin Falls, Pocatello, etc)
Along I-15 between Pocatello ID & Ogden UT
Along I-84/I-80 between Ogden UT & Cheyenne WY
I know it's a long shot, but figured I'd ask.